What pump is everyone using for there ato

[charliethetuna88]

What pump is everyone using for there ato ..I've been using Tom's aqualifter pumps ,I'm really tired of fixing them and buying new ones ...what's my other options ..I was thinking like a small seio

 

[theMeat]

I use a small aquaclear. Even run kalk and has been going flawless for years

 

[MIKE NY]

MJ1200...no problems for years even with kalk added


Sent from my iPhone using Tapatalk

 

[reefiness]

Tunze and pmup

 

[vio]

For last 15 years, flout valve , direct from RO/DI filter, never problem.
Fill out when level go down ( evaporation).

 

[reefiness]

For last 15 years, flout valve , direct from RO/DI filter, never problem.
Fill out when level go down ( evaporation).

this causes tds creep which will make you go through di resin quicker and generally not recommended.

 

[grsfish]

I?ve used the tunze ato Without problems

 

[Ligershark]

i use the tunze osmolator but i have been looking for a way to use an optical sensor to over ride and shut off the pump when my ato container runs out.

 

[dennis]

Neptune Apex ATK.

 

[reefiness]

i use the tunze osmolator but i have been looking for a way to use an optical sensor to over ride and shut off the pump when my ato container runs out.

you would need help from apex for that.

 

[jd371]

i use the tunze osmolator but i have been looking for a way to use an optical sensor to over ride and shut off the pump when my ato container runs out.

I made a simple low water warning set up to let me know when the ATO container is close to empty. I installed a float switch near the bottom of the container and ran the wires to two AA batteries and then to a LED that I attached to the front of the stand. When the water level gets low enough to trigger the LED I know that I have another day left before the container is empty.

 

[nycfishy]

avast diaphragm pump, no head pressure issues and been rock solid