MagDrive 9.5 thread size?

[doctor_random]

I have a MagDrive 9.5 that supposedly has 3/4" FIP/MIP threads, according to multiple spec sheets on multiple websites (including original manufacturer).

I ordered a bunch of 3/4" MIP/FIP plastic fittings for this pump (from a source recommended by the MagDrive people) and the threads on the fittings I bought are too coarse (fitting have thread count too low to fit on the pump without cross-threading.)

Are there different thread counts for these kinds of fittings?

If so, where where should I look the correct fittings? I havn't found any B&M stores with them to actually go and see if they fit.

Thanks

Threadless in Manhattan:irked:

 

[NYreefNoob]

yes there's different thread size's. home depot will have the fittings that fit it

 

[doctor_random]

HD fittings....

Well, no Home Depot I have ever visited has anything close.

Typically only brass, or limited John Guest fitting supply.

Which Home Depot do I have to schlep to? :Hydrogen:

 

[doctor_random]

Bump

 

[ecvernon]

i have bought some (maybe spelled wrong) savco fittings from lowes in brooklyn they fit on my mag drive. find a lowes close to you they usually have everything and you could actually find it

 

[masterswimmer]

I get mine at any HD or Lowes. If you're looking by the JG or brass fittings, you're in the wrong area. These fittings are normally located separate from the two I just listed.