PH Controller

[littlefish]

Does anyone knows about the Smart PH Controller?
Also (it may seem a stupid question) Do I need the PH solution that comes with it and if so whic one: 4.01, 7.01 or 10.01 ?
I've never use a calcium reactor so I don't know much about this.

Thanks like always.

Alfredo.

 

[crox99]

You would need the 7 and 10 to calibrate the probe.

 

[regal]

If you are looking into a pH controller, you should consider the aquaJr. It does the job as a pH controller and more. It monitors your temp and control your chiller or heater, control your topoff, pumps and lights and more. As far as calibration solutions, you need either the 4.0 or the 7.0 for low-point calibration and the 10.0 for the high.

 

[littlefish]

Aqua JR

Just order the Aqua JR.
Thanks for the advise. After reading about it, I agree is what I need.

Thanks again.

Alfredo

 

[cali_reef]

You will need 4.0 and 7.0 calibration fluid packets to calibrate the probe for a Ca reactor.

 

[meschaefer]

I love my ACjr

 

[Chiefmcfuz]

As far as ph probe calibration fluid when you're ready for it let me know I drive through the north bronx almost every nite and I have plenty of 7 and 10 fluid.

 

[tripstank]

Which Aqua Jr. package did you order. I am interested in one too. I need it to control a CA reactor, and perhaps my lights if it can handle the amperage, and my heater/chiller.