M mutley29 Advanced Reefer Rating - 0% 0 0 0 Jan 24, 2009 #1 Does anyone know where you can buy the parts holding the Controller probes in place on this photo from OregonReef? Was thinking of doing a similar setup on my system, and don't know where to get those parts.
Does anyone know where you can buy the parts holding the Controller probes in place on this photo from OregonReef? Was thinking of doing a similar setup on my system, and don't know where to get those parts.
M mutley29 Advanced Reefer Rating - 0% 0 0 0 Jan 24, 2009 #2 NVM, i think i found them here http://www.aquaticeco.com/subcategories/3367/Cord-Grips
M mutley29 Advanced Reefer Rating - 0% 0 0 0 Jan 24, 2009 #4 My bad, better pic from Oregon Reef here
A Anonymous Guest Rating - 0% 0 0 0 Jan 24, 2009 #5 So the answer is yes they are right in the pipe Very slick way of doing it, making sure water is always flowing past the probes. Only issue I see with a setup like that is you have to shut off the water to the pipe to clean or replace the probes.
So the answer is yes they are right in the pipe Very slick way of doing it, making sure water is always flowing past the probes. Only issue I see with a setup like that is you have to shut off the water to the pipe to clean or replace the probes.
A Anonymous Guest Rating - 0% 0 0 0 Jan 25, 2009 #6 Zoo Med makes new magnetic probe holders. So no more suction cups! I just ordered them from Marine Depot.
Zoo Med makes new magnetic probe holders. So no more suction cups! I just ordered them from Marine Depot.
