Bertdog

Experienced Reefer
Location
westchester
Rating - 100%
19   0   0
using RO/DI water system but ending up with PPM 004 after sitting in holding can.

Purtrex 5 Micron Sediment Filter
MATRIKX CTO 5 Micron Carbon Block
MATRIKX CTO 0.6 Micron Carbon Block
(2) Color Changing DI Resin Canister
(2) 75 GPD water saving upgrade kit to 150

ppm coming into unit after membrane is 0
ppm coming out of final hose is 0

(1) in my rubbermaid 32 gal which I wipe down before refilling with paper towels , then rinsing with some RO . I get a reading of 4 ppm after its sitting in can . I test with my TDS the water that comes right out I?m at 0. Any suggestion on what I can do to the can , its never been use for anything else other than water.

(2) Also I have 32 gal of water and not sure if I should use it for water change with 4 ppm or is there something to add to the water to lower the ppm before adding salt.

(3) I have recently set up an automatic refill my top off tank . In the past I would run my RO for a little bit till I got a 0 reading from 1 or so , is anyone doing anything to check RO in top off to be 0. I have check the water in there (my top off tank)is still at 0 so not an issue as of yet. Just wondering whats being done .

Thanks in advance for any input.
 

Sponsor Reefs

We're a FREE website, and we exist because of hobbyists like YOU who help us run this community.

Click here to sponsor $10:


Top