wow, just to say the least. Deep blue epic fail!!
The stand does not match up to the tank properly. The bulkheads hit the available hole in the stand by almost 1 1/2". I don't want to cut it but it will look half way retarded not fully on the stand.
I don't know what tool to utilize to cut a nice clean curved circle. I have a hack saw and a dremel. This sucks!!
Does anyone have a suggestion?
Thanks,
mike
Also, anyone in NNJ want to weld me the metal tubings found in home depot to create a light fixture stand??
Please let me know. Willing to give a frag of something or twenty bucks for about 5~ welds + a few cuts. I rather not go to home depot and make electrical conduit bends again.
The stand does not match up to the tank properly. The bulkheads hit the available hole in the stand by almost 1 1/2". I don't want to cut it but it will look half way retarded not fully on the stand.
I don't know what tool to utilize to cut a nice clean curved circle. I have a hack saw and a dremel. This sucks!!
Does anyone have a suggestion?
Thanks,
mike
Also, anyone in NNJ want to weld me the metal tubings found in home depot to create a light fixture stand??
Please let me know. Willing to give a frag of something or twenty bucks for about 5~ welds + a few cuts. I rather not go to home depot and make electrical conduit bends again.