Customizing your stand!

[evoIX_Reefer]

This is probably better in the DIY section but probably more views and quicker answer in this section.

I want to see solutions for covering holes drilled into your stand!!

I want to drill the side of my stand to display a controller rkl/rke/apex display and my AI controller. Do you have a black plastic solution that can cover the wood showing?

I will try to locate an example.

 

[dacaptain78]

Why dont you just drill a hole just large enough for the wires to run through and mount the controller over the hole?

 

[evoIX_Reefer]

it looks a lot cleaner if it is flush. once i find the example then you will get a better picture of what i am looking for. i forget if it was breakin newz or constantne that did it.

 

[dacaptain78]

I see. You can use some laminating strips or edge banding to give the exposed cuts a finished look.

 

[Tonyscoots84]

i see. You can use some laminating strips or edge banding to give the exposed cuts a finished look.

+1

 

[strgazr27]

I have used Doll House molding. Sounds crazy but it's a great scale and size and comes in as many styles as regular molding does.

 

[bigyankfan]

Is this what you are looking for? If so, go to rockler.com.

 

[evoIX_Reefer]

Looking for a more square version and a fully open circle but overlaps the edges like the above wood. I have to look into the other posts suggestions.

 

[skene]

You can always put another thin piece of ply with a cutout sized for the controller you want... that way it will give a more flushed look.