Thin frag plugs

[jlm080307]

Looking for recommendations on thinner frag plugs that are easy to cut thorough.
Thanks!

Sent from my SM-G930V using Tapatalk

 

[cmantis]

If you want to just break off the base get the non ceramic kind like oceans wonder. Very easy to snip/break off.

 

[reefiness]

If you want to just break off the base get the non ceramic kind like oceans wonder. Very easy to snip/break off.

I was going to recommend oceans wonders. They are my favorites. pretty thin aragonite plug so its pretty easy to manipulate.

I think the ceramic plugs are actually pretty easy to manipulate too as they also tend to be pretty thin. I just prefer the oceans wonders for SPS because they seem to encrust those plugs better than the concrete and ceramic ones I've used.

 

[Marek-S]

That's what I like to use also

Sent from my iPhone using Tapatalk

 

[charliethetuna88]

I went thf ew the same think looking for the the thinnest, disk /plugs .I like these the best, alternative reef

 

[bonomo53]

You should be able to cut any the of the plugs with bone cutters. Only ones that can't are those little stubby ones or the ora ones.

 

[ourcoralreef]

You should be able to cut any the of the plugs with bone cutters. Only ones that can't are those little stubby ones or the ora ones.

+1
This is exactly what i was going to say get a set of bone cutters

 

[jlm080307]

+1
This is exactly what i was going to say get a set of bone cutters

Agreed. I just feel like I can control the cut more in a thinner plug.

Sent from my SM-G930V using Tapatalk

 

[ourcoralreef]

Agreed. I just feel like I can control the cut more in a thinner plug.

Sent from my SM-G930V using Tapatalk

Its wet sticky sometimes encrusted etc for me one swift movement where I?m not holding any part of the plug is the ideal situation

What kind of control do you leave a stub or you like to make it a clean cut so it becomes a disk