STRIPERVIPER

Advanced Reefer
Location
LONG ISLAND
Rating - 98.8%
161   2   0
So I have the apex ato and it's not operating properly. Assuming I have the program wrong. It usually goes low then fills it up to the second optical eye. I thought it was supposed to just use the lower eye as the on off switch with the higher eye as an emergency off switch and then the float switch as a fail safe. Plus the other day it didn't function at all and when I looked at my fusion it had the pump in off position instead of auto. I'm guessing that's because the pump ran for too long causing a timing trigger. I don't kno how to program it and I had it done by a friend. Any advice appreciated. The pictures are of my fusion screen as it usually appears and the program in the pump settings screen.
 

Attachments

  • IMG_2302.jpg
    IMG_2302.jpg
    22.2 KB · Views: 108
  • IMG_2303.jpg
    IMG_2303.jpg
    22.2 KB · Views: 112

Kworker

Advanced Reefer
Location
Long Island
Rating - 100%
71   0   0
Mine looks as such:

1- Fallback OFF
2- If Sw1 OPEN then OFF
3- If Sw1 CLOSED then ON
4- Min Time 000:10 Then ON
5- Defer 000-10 Then ON
6- If Sw2 OPEN Then OFF


For what its worth. I didn't set it up, I bought it secondhand.
 

STRIPERVIPER

Advanced Reefer
Location
LONG ISLAND
Rating - 98.8%
161   2   0
Should look

This is how it should look I imagine. The higher eye open and the lower eye almost always closed. Remember they're reversed in the fusion. The lower eye is named ok the higher named high.
 

Attachments

  • IMG_2315.jpg
    IMG_2315.jpg
    22.8 KB · Views: 63

Sponsor Reefs

We're a FREE website, and we exist because of hobbyists like YOU who help us run this community.

Click here to sponsor $10:


Top