plumbing overflow

[jkidd155]

so i got my new tank put it on the stand but for some reason where the holes on the bottom of the tank r one of the holes is in between one of the braces can i take it out without messing up the structure of the stand here r some pics any help will be appreciated

 

[Chefjpaul]

Just notch it out a bit

Sent from my SAMSUNG-SM-G935A using Tapatalk

 

[jkidd155]

wat if i removed it n placed it a little bit lower than notch would it mskr s difference

 

[dorry54]

hard to see in the photo , can you add a 2x4 member on the inside, then cut the wood shorter. secure to the inside support instead

 

[jkidd155]

I was thiking about just moving it down a couple inches just enough to get clearance thnks for advice

 

[265]

u don't need the inside 2x4 if u have one on the outside

 

[jkidd155]

Oh k so I can remove it n have no problems also I put the tank on the stand n da bk has a little gap wat can I do about that

 

[piranhapat]

Your talking about 1/2 space in the back. Where your going to lower the 2x4. Once you lower it place 1/2 wood in between and screw it into 2x4. So they no gaps between the 2x4.

 

[jkidd155]

i have 2 pieces of 2x4 in the middle for support i think its warped bcuz the rest of the tank sides and front r flushed not sure i just took out the leveler and every angle is spot on in the middle wat could it b?