Leak proofing CO2

[Fishnet]

Hi all,
Just got my DIY reactor up and running. I have a milwaukee brand regulator,solenoid, and bubble counter as part of my setup. In addition to the teflon tape on the regulator's input, do I need to add teflon tape on the guage, solenoid, and bubble counter assembly as well to leak proof the entire assmbly??
Thank You

 

[npaden]

You probably don't need teflon tape even where the regulator screws on to the co2 tank if there is an O-ring in the regulator. Most regulators I've used or seen have O-rings on most of the connections and don't need teflon tape at all.

If you are worried about leaks you can always mix up some soapy water and splash it around a bit and see if there are any bubbles.

My 2 cents.

Nathan

 

[ChrisRD]

I agree with Nathan. IIRC use of teflon tape on the regulator to tank connection is actually discouraged because there's a chance a bit of the teflon can end-up inside your regulator.

 

[Anonymous]

Ditto to ditto.