How do I set my doser?

[LeslieS]

I purchased a used aquamedic doser, but it didn't come with the instructions. Can someone tell me how to set it?

Thanks,
Leslie

 

[noodleman]

its not really that hard to set it up, so let me see can i just post it...

1) hold enter and set at the same time...then you'll see the LED ont he channels start to blink, keep holding till you get to the channel you want to set up than let go of the 2 buttons

2) once you let go you'll see four number slots,....these four number slots corresponds to how far apart you want to dose (ie. 00.00...first two numbers are for hours and last two are for mins.....so if you set like 03.05, it'll dose every 3hour and 5 mins). To move from number to number you just press set and adj is to adjust ......when you done setting the time press enter and it'll start flashing and press set again.

3) Now you will see another four number slots, and two more number slots as you continue...these numbers coressponds to the amount of time your doser will be on everytime you dose. ( ie. 00.00.00...so say you have 00.00.10, everytime your doser will turn on, it'll run for 10 seconds) You set this in the exact same manner as before, and when your done press enter and set again.

4) repeat this for all channels...then press set and enter at the same time to activate.

hope that helps
p.s. run each pump for a min and measure how much they each dose, they might not be the same

if you need more help, bring it to the swap and i'll show you

 

[Deanos]

AquaMedic ReefDoser

 

[LeslieS]

thanks Dean!