- Location
- Hudson Yards
I bought a used American Marine Pinpont pH controller and I'm having trouble setting the high and low points. It didn't come with the manual, but I did go to the American Marine web site and down load the documentation. It wasn't a whole lot of help.
I set it up last night hooked up Coralife Calcium reactor and thought I had accurately set the low point to 6.8 and the high point to 7.0. But when I woke up this moring and checked on it, the reading was 6.2 and the solenoid was still on. Can anyone help me figure this out?
I set it up last night hooked up Coralife Calcium reactor and thought I had accurately set the low point to 6.8 and the high point to 7.0. But when I woke up this moring and checked on it, the reading was 6.2 and the solenoid was still on. Can anyone help me figure this out?
