Hi ILikeFish ;-)
It's been 21 years now that I keep marine systems and 32 since I started with my first tank. I've only had two minor leak episodes, one with a freshwater tank caused by having placed a bucket filled with new water on top of one of the corners while the water was being siphoned from it into the tank, which caused a slight dislodgement of the silicone joints and some water leaked (one or two gallons). The situation stopped as soon as I removed the bucket from the corner top and the joints regained their original position. The other leak was caused by over skimming in a nano tank that I once had. The external skimmer started to produce foam like crazy several hours after I fed some red plankton and since I was not home at the time...it drained one quarter of the tank water out to the floor...:irked: and caused me to loose a Caulastrea sp. coral that remained several hours exposed to the air as if it was low tide exposure:irked:.
Searching the forum I found these reports of such unfortunate incidents. There's possibly more, but these were the ones I could find.
Help My Tank Is Leaking (
1 2)
Help! Leaking return pipe
Tank Leaking Forces Sale (
1 2)
Emergency Breakdown, all live stock needs to go
now this one here
Emergency Measures to use NOW (
1 2 3 ...
Last Page) is also important as frequently tank leaks cause failures, and it it good to know wath to do also to face this possible consequence.
ILikeFish said:
I am fairly new to the hobby and have not experienced any major leaks yet. I purchased my tank used and is quite old. I has a couple small chips in the glass in one of the corners. Can this be repaired? Is this a potential problem? Will I come home to a flood! :tub::irked:
Prior giving you any advice, which could be inaccurate due to lack of data, could you please put some photographs of the areas you judge potentially critical so that we may evaluate and answer accordingly? Also one other very important aspect to consider, especially when dealing with an old tank, is the condition of the silicone joints, or existing joints, as these degrade over the years and have to be checked for safety, especially when the tank was left empty of water for a long period of time. Usually a water tightness test is carried before anything else, and this done by progressively and slowly filling up the tank with fresh water until full and leave it like that several days, after which and if no problems are detected, the water is drained, the tank cleaned, and set ready for service.
Looking forward to read form you with more details, photographic ones if possible, so that we may better help you.
Cheers
Pedro Nuno ;-)