Help! My Aquacontroller 2 is not working properly

[brick-brothers]

Hey guys, I just hook up my aqua controller 2. I made sure all the I.D. settings for the modules and controller are correct. But the controller still isnt turning on and off the power to these modules. What else should I do?

 

[Awibrandy]

Hi Manny, I'll try to get intouch with Melt asap, and get back to you. Is it ok to give him your #?

 

[Awibrandy]

Manny, I called Melt, and he said for you to pm him with your #.

He is currently on the road, but will call you as soon as he gets in, and walk you through it.
In the mean time I'm not sure if I understood him correctly, but I believe he said to make sure everything is hooked upto what you have programmed into it.

Please let me know how this turns out!!

 

[qy7400]

A few things I can think of...

Is the AC setup for AUTO? What happens when you try manually setting them to ON?
Does the control box LED flash when you send an ON/OFF command out?
Are the X10 modules all plugged into the same line as the control box, there were known issues with the X10 signal not reaching across the fuse panel.

A quick test would be to plug the control box and module into a power strip and see if it works.

 

[brick-brothers]

sure npo problem.

Hi Manny, I'll try to get intouch with Melt asap, and get back to you. Is it ok to give him your #?

 

[brick-brothers]

The x10 controller works perfectly. But LCD controller is the part thats not working. Each module is assign to auto. lets say when I choose the feed mode. The controller doesnt send out the signal to the modules to turn off the pumps.

A few things I can think of...

Is the AC setup for AUTO? What happens when you try manually setting them to ON?
Does the control box LED flash when you send an ON/OFF command out?
Are the X10 modules all plugged into the same line as the control box, there were known issues with the X10 signal not reaching across the fuse panel.

A quick test would be to plug the control box and module into a power strip and see if it works.

 

[Melt]

Hi what's up. Did you program the feed mode with the same setting as the x10( A1 and so on) does the other x10 respond to the controller? If you do it manually does it work?

 

[brick-brothers]

I'm assuming thats my problem. The x10 is not responding to the controller. I can control the modules from the x10 but not the controller.

Hi what's up. Did you program the feed mode with the same setting as the x10( A1 and so on) does the other x10 respond to the controller? Lmk

 

[Awibrandy]

Manny, I gave Melt your # just now when he called me, and he will be calling you now.