90 gallon Justin_NY

[Justin_NY]

Oh my GOD this thing is so slow

 

[jackson6745]

Water is cold, slows it down. If you hot water is comparable tds make it a little warmer.

 

[Justin_NY]

But i thought warm water make unit goes bad

 

[jackson6745]

But i thought warm water make unit goes bad

I dunno. I have been doing that for the last 10 years. My membranes last a long time.

 

[Justin_NY]

5 hours pass only 1/4 tank

 

[Justin_NY]

Playing around with the rock:biggrin:

 

[Tonyscoots84]

that rock should of been in the tank 1st then sand... make sure you dig your rock into the sand so it reaches the bottom of the tank glass. looks good so far. its exciting isnt it

 

[Justin_NY]

Its done today.

 

[Justin_NY]

New member of the family

 

[Shamer]

Looks good, where did you get the dry rock from? Did you cook or cycle the rock before you put it in the tank?

 

[Justin_NY]

I got the rock from another member in MR.
I dont cook or cycle the rock cause its a dead rock. Its been staying oitside his house for long time. I just rinse and clean the rock.

 

[Justin_NY]

Buttom tank picture

 

[Justin_NY]

Im triying to install calcium reactor, but i have a little bit worry.
I bought this reactor from another member in MR, but he never used it.
On the top of the reactor thre is a hole to put ph probe. Is this thing just slide in? Or u have to put glue?
Im worry for big leak. So far what iknow this reactor is high pressure.
The reactor made from my reef creation.
Here the picture iam talking abt

 

[fcamargo6thave]

Your tank is looking nice buddy. So you are recuring the rock? i am in the same process of using dead rock i had sitting outside for months and boy does my house stink lol.

 

[Shamer]

Im triying to install calcium reactor, but i have a little bit worry.
I bought this reactor from another member in MR, but he never used it.
On the top of the reactor thre is a hole to put ph probe. Is this thing just slide in? Or u have to put glue?
Im worry for big leak. So far what iknow this reactor is high pressure.
The reactor made from my reef creation.
Here the picture iam talking abt

I had a reef octopus reactor and it had an O-ring fitting at the top. When you put the probe in the fitting you would get a tight seal. I wouldn't use glue to put it in since you'll need to pull the probe out and clean it every few months.

 

[Justin_NY]

I dont see any o ring

 

[Justin_NY]

Pick up come coral
Update picture of my tank

 

[Justin_NY]

Elegence coral

 

[Justin_NY]

Sps

 

[Justin_NY]

Yellow acro