A
Anonymous
Guest
My reactor stopped working again but this time the maxijet feeed pump stopped and needed to be cleaned. In the past its been too much CO2 building up in the reactor or the CO2 stopping for seom reason.
I have a drip rate right now about 1 drip per second. I also have the co2 set at 1 bubble every 3 seconds or so.
Is this where I need it to be? Should I do anything different?
My levels had dropped to 7.6 DKH and 320 on the CA. I also run a Kalk reactor that does not do a good job in maintaining CA either. Ive been adding super buffer and Turbo CA to try and raise the levels back up.
I have a drip rate right now about 1 drip per second. I also have the co2 set at 1 bubble every 3 seconds or so.
Is this where I need it to be? Should I do anything different?
My levels had dropped to 7.6 DKH and 320 on the CA. I also run a Kalk reactor that does not do a good job in maintaining CA either. Ive been adding super buffer and Turbo CA to try and raise the levels back up.