Mp 10 for 125g tank....

[mheaven]

Hello everyone I was wondering if a mp 10 would work on the thickness of a 125g tank. I'm not sure what the glass thickness is on a 125g but the mp 10 can work on glass up to 3/8" thick. Any input would help... Thanks, Danny.

 

[evoIX_Reefer]

Getting back in the hobby?

 

[Chiefmcfuz]

The glass will be too thick. Plus the flow will be severely inadequate.

 

[Master Shake]

wont work i believe glass is around 1/2-3/4 inch give or take a bit. flow will be highly inadequate if it even manages to have enough strength to stay on the glass

 

[lfsmarineguy]

Definitely not 3/4" on a stock 125g it's closer to 1/2".

 

[Master Shake]

i said give or take jared its been a long week, still would you use a mp10 on a 125?

 

[mheaven]

I'm not worried about the flow from the pumps, I'm just wondering if they will stay on the glass. The proper flow I have it covered already. Looking to fill dead spots if needed with the MP 10's.

Evo yes I'm back, I've beed back with a 40b for about 10 months. But I just purchased a 125g for my upgrade.

It's not going to be a full blown reef, Keeping it simple this time around.

 

[pecan2phat]

I don't think that a perfecto or deep blue standard off the shelf 125g tank would be 1/2" glass, more like 3/8".
Someone measure their non-custom 125g :lol:

 

[mheaven]

I'm thinking the same pecan.... 1/2" seems a bit over kill.

 

[tomtoothdoc]

i wouldn't trust it to stay put. i had an mp 10 that kept falling off a 75.....not every week but a few times, often enough that i just traded for an mp 40 instead.
welcome back danny.....want your kalk reactor back? i got an avast kalk stirrer....liking that more than the pm with the maxijet.