- Location
- East Yaphank
Okay okay I'm sure we've all seen these posts about what salt to use, how to mix it, how long to mix it etc, but looking for advice on how to set it up.
I have a Wayne pump (similiar to what is below) with the intake on the bottom and the output nozzle on the side.
I have a Brute garbage can that I would like to mix salt in, and since it is a fairly strong pump it should do it fairly quickly. My issue is that due to its power and not being mounted to anything this pump just wants to spin to the point that it would like to snap the power plug off.
Is there anything I could attach this to to prevent it from spinning like a tornado? The unfortunate parte is that the output isn't center mounted so even if i took the nozzle off the end it would still spin.
I have a Wayne pump (similiar to what is below) with the intake on the bottom and the output nozzle on the side.
I have a Brute garbage can that I would like to mix salt in, and since it is a fairly strong pump it should do it fairly quickly. My issue is that due to its power and not being mounted to anything this pump just wants to spin to the point that it would like to snap the power plug off.
Is there anything I could attach this to to prevent it from spinning like a tornado? The unfortunate parte is that the output isn't center mounted so even if i took the nozzle off the end it would still spin.



