ReefKeeper iTemp Question.

[Hungriee]

Today I finally had time and set up my RKL. I connected the iTemp probe to the PC4 and mounted the probe holder in the tank. I have the probe about halfway submersed in water. At first I noticed the temperature fluctuating very fast and seemed somewhat accurate in the low 80s.

Then I got curious and played with the menu and ended up in Inputs and calibrated my temperature to 76.8. I noticed the temperature on the display change to 76.8 and since then it has not fluctuated back to the low 80s (which it should be at).

The only temp difference I've noticed is 76.7 -76.8. Can anyone explain what I did wrong, and what to do to fix it to accurately measure the tank's temperature again? I tried to do a factory reset but noticed it doesn't fix the module settings, so I'm screwed.

Read more: ReefKeeper iTemp Question

 

[Josh]

The device was factory calibrated, if you changed it you need to make sure you calibrate it properly.

To check if it is working take the probe out of the water and see what the temp changes to. It will work in air as well.

 

[afernandez]

I don't think u changed it I think it finally settled
get another type of thermameter and double check it .